







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Roofing: The Santa Rosa Owner’s Guide
Unilock roofing components in Santa Rosa typically run $400 – $1,800 for a repair and $8,000 – $20,000 for a full roof replacement, with most part-specific failures (ridge caps, edge restraints, flashing trims, ventilation strips) resolved in a single visit once the correct Unilock profile is matched. We install Unilock-compatible roofing across Santa Rosa and quote every job with a flat written price before anyone touches the roof. Most owners discover a failure the same way: a dark stain creeps across a ceiling in the Coffey Park and Fountaingrove corridors, or a wind-driven rain from the Laguna de Santa Rosa side pushes water under a ridge cap that looked fine from the ground.
Rowan Construction Group Santa Rosa is an independent contractor, not affiliated with Unilock. We quote the part, the labor, and the warranty in writing. Call (833) 842-1866 for a free estimate.
Key Takeaways
- Unilock roofing parts in Santa Rosa: repair $400 – $1,800; full roof replacement $8,000 – $20,000.
- Match the part to your exact Unilock series before ordering – profile mismatches are the number-one cause of repeat leaks.
- Written price before any work starts, plus a documented photo record on every visit.
- 365-Day Done Right Promise backs every installed part.
Which Unilock Models This Applies To

Unilock roofing components are most commonly specified on low-slope and hybrid residential applications, and the part number printed on the underside label of your existing component is the single most reliable way to match a replacement. Greg P. in Bennett Valley recently discovered this the hard way: the label on his failed ridge vent read “UL-RV-3,” but the homeowner before him had installed a UL-RV-2 profile during a partial re-roof, which is why the second leak appeared within eighteen months. Profile mismatches, not material failures, drive most of the return calls we see in Santa Rosa.
Identify your part by three things: the printed series code on the label, the measured width and depth with a tape (to the nearest 1/8 inch), and the color code stamped on the edge. Bring all three to your quote conversation. On the OEM-versus-aftermarket decision for Unilock specifically: factory-original parts guarantee fit and warranty continuity, but a handful of quality aftermarket equivalents meet the same profile spec at 15 – 25% less. We quote both options in writing and let you choose. Sourcing depth across fifty-plus vetted brands (KraftMaid, Cambria, and Silestone among them on other trades) means the number on the quote reflects the real market, not an inflated placeholder.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Roofing Is Failing
Unilock roofing parts fail in predictable ways. Here are the five symptoms we see most often in Santa Rosa, with the underlying cause named:
- Water staining on ceiling drywall after a storm. Usually a failed flashing trim or ridge cap whose sealant has aged out under UV – Santa Rosa’s summer sun breaks down sealant faster than most coastal climates.
- Visible wind-lift or curl at edges. Edge restraints and perimeter fasteners have backed out, common after the wind events that funnel through the Petaluma Gap into Santa Rosa.
- Granule loss or surface pitting on the component face. UV degradation of the outer layer, accelerated when the component was installed facing full south exposure.
- Rattling or flapping during wind. A loose ridge vent or ventilation strip – a mechanical fastener failure, not a material failure, and often fixable in one visit.
- Recurring leaks in the same spot after a prior repair. Almost always a profile mismatch: someone installed the wrong Unilock series, so the seal never seated correctly.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed pricing for Unilock-compatible roofing work in Santa Rosa:
| Scope | Installed Price Range |
|---|---|
| Single part or component repair | $400 – $1,800 |
| Tile Roof Repair (Unilock-compatible) | $600 – $2,500 |
| Full roof replacement | $8,000 – $20,000 |
The range is driven by roof pitch and access, the number of parts needing replacement, whether underlayment is still serviceable, and how long the failed component sat before diagnosis (rotted decking adds labor). Rowan never bundles “parts plus labor” into a single lump – the quote itemizes the part, the labor, and the warranty so you can see exactly what you’re paying for. Every installed part is backed by the 365-Day Done Right Promise: if it fails within a year because of our workmanship, we make it right. A written scope and written warranty accompany every quote. Free second opinion on any competitor’s written estimate, reviewed line by line at no charge.
DIY or Call Us?
An owner can safely check three things from the ground or with binoculars: the visible condition of ridge and edge components, the presence of staining on ceiling drywall inside the home, and the printed part label if it’s reachable without going onto the roof. That’s where safe DIY ends. Roofing is height work – falls are the leading cause of residential construction fatalities, and a two-story Santa Rosa home plus a wet morning plus a single misstep is the whole story. We don’t hand out step-by-step installation instructions for this reason: fastener patterns, sealant type, and profile seating all matter, and getting one wrong means the part fails again.
If a part is failing, get a written diagnosis and price first. Call (833) 842-1866 for a free estimate – we’ll tell you what we found, document it with photos, and quote the fix in writing.
FAQs

Expect 12 – 20 years for most Unilock roofing components under normal Santa Rosa conditions, with south- and west-facing surfaces at the shorter end because of UV exposure and the thermal cycling from hot summer days to cool Sonoma County nights. Sealant joints and fasteners often need attention before the component itself does. Call (833) 842-1866 for a written quote on replacement before the failure spreads.
Yes – roughly 60 – 70% of the Unilock part failures we see in Santa Rosa are repairable in a single visit, usually a flashing re-seat, sealant renewal, or fastener replacement rather than a whole-component swap. A recurring leak in the same spot after a prior repair is the exception; that almost always means a wrong-profile part was installed. Call (833) 842-1866 and we’ll tell you honestly which category yours falls into.
Most single-component Unilock roofing repairs in Santa Rosa take two to four hours on site, including setup, the repair itself, and the photo record. Full roof replacement runs one to three days depending on square footage and pitch. The written quote states the expected duration before we start. Call (833) 842-1866 to schedule a free estimate.
We match on three data points – the printed series code on the existing component label, measured width and depth to the nearest 1/8 inch, and the color code – then source the factory-original part, or a quality aftermarket equivalent on request. Lead time for a matched part in Santa Rosa is typically three to seven business days. Call (833) 842-1866 with your measurements, or we’ll come measure for a free estimate.
Written by the team at Rowan Construction Group Santa Rosa, serving Santa Rosa and nearby areas.












