







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Toto Bathroom Remodeling: The Santa Rosa Owner’s Guide
Toto bathroom remodeling in Santa Rosa typically runs $9,000 – $28,000 installed, depending on whether you’re replacing a failing fill valve in a single Drake or rebuilding a primary bath around a whole Toto suite (Neorest, Washlet, Ultramax). The work is plumbing and tile, planned, not emergency. What brings most owners here is a symptom they’ve been living with for weeks: a toilet that runs for 30 seconds after every flush, a slow fill that leaves the bowl at half level, a Washlet wand that stopped extending, or water pooling at the base after a shower.
We install and service Toto-compatible bathroom remodels across Santa Rosa, from the 1920s bungalows on McDonald Avenue to the newer builds off Fountaingrove Parkway. Every visit includes a documented photo record, and every quote is a written price before anyone touches a flange.
Key Takeaways
- Installed Toto bathroom remodels in Santa Rosa: $9,000 – $28,000, quoted in writing before work starts.
- Most single-fixture failures trace to fill valves, flappers, or supply lines – not the ceramic.
- Toto uses model-specific parts; a generic flapper will fit but fill at the wrong rate and run.
- We’re an independent contractor, not affiliated with Toto. We source OEM and quality aftermarket parts by model number.
- Free second opinion on any written Toto estimate you’ve already been given.
Which Toto Models This Applies To

Toto’s residential line splits into a few families, and the part you need depends entirely on which one you own. The Drake (CST743) and Eco Drake (CST744) are two-piece toilets with a G-Max or E-Max flush valve – the 3-inch flapper and fill valve differ between the two, and getting the wrong one is why so many Santa Rosa installs whistle or run. The Ultramax and Ultramax II (MS604) are one-piece with an integrated fill tower. The Neorest and Washlet lines add electronics – seat, wand, pump – which fail on a different schedule than the porcelain does.
Find the model on the label inside the tank lid or on the back of the bowl near the seat hinge. It’s usually a five-to-seven-character code (CST743E, MS604124CEFG). Measure the tank width and the distance from the wall to the flange bolt centers – 10-inch, 12-inch, and 14-inch rough-ins all exist, and a Santa Rosa plumber quoting a full replacement needs that number.
OEM vs aftermarket: Toto’s own fill valves and flappers are built to the exact flow rate its bowls are designed around. A generic Fluidmaster works, but on Eco Drake models the 1.28-gallon flush depends on a matched fill, and the wrong aftermarket part costs you 20 to 40 extra gallons a day. On Washlet electronics, OEM only – we don’t source third-party control boards.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Toto Bathroom Remodeling Is Failing
Owners usually discover the problem in the middle of a season change, when water pressure shifts and a marginal part gives out. Here’s what to watch for, and what it usually means.
- The toilet runs for 20 to 60 seconds after every flush. That’s a flapper that no longer seals on the seat – the rubber hardens and skews with age, and the tank leaks down until the fill valve kicks on. On a Toto with a 3-inch flush valve, a 2-inch generic flapper won’t seal right and the run never stops.
- The bowl stays at half level after flushing. The fill valve is restricted or the refill tube isn’t clipped into the overflow. On Eco models this often traces to a mis-installed aftermarket valve that fills the tank but not the bowl.
- A whistling or hissing from the tank that never fully stops. The fill valve’s internal seal is worn. In Santa Rosa’s harder water, mineral buildup accelerates that wear, especially on homes fed from older galvanized service lines.
- The Washlet wand won’t extend, or the seat heat won’t turn on. That’s the electronic control or pump on a Neorest or Washlet – a part you replace by panel, not by feel. It’s also where a novice DIY attempt voids the electronic warranty.
- Water at the base of the toilet after a flush or shower. A failed wax ring, a cracked flange, or a failed shower pan membrane. In Santa Rosa’s older homes, a 1950s cast-iron closet flange has usually cracked by now, and the wax ring is doing 100% of the sealing work.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Santa Rosa, the numbers below are market ranges we see on real jobs, not aspirational. Each one is a written flat price with a written scope – parts, labor, haul-away, and the warranty line all named on the page before work starts.
| Scope | Installed range |
|---|---|
| Bathroom remodel, full (Toto fixtures, tile, waterproofing) | $9,000 – $28,000 |
| Small bathroom remodel (single-fixture refresh, Toto toilet) | $5,000 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Bathroom vanity installation | $800 – $3,000 |
What drives the number: whether the flange is sound or needs rebuilding, whether the subfloor under the toilet has soft spots (common in Santa Rosa homes with older plumbing), the tile scope, and whether you’re staying with existing fixtures or moving to a new Toto suite. Parts-plus-labor is transparent on the quote – we list the fill valve or flapper separately from the labor, so you see what the part costs.
Workmanship is covered by our 365-Day Done Right Promise: if it’s not done right, we make it right. Under Clause 1 of the Haven Standard, the price is written before anyone picks up a tool. We’re independent – not affiliated with Toto.
DIY or Call Us?
An owner can safely check three things: the tank label for the model number, whether the flapper is visibly warped or mineral-crusted, and whether the water line behind the toilet has a shutoff that actually turns. That’s it.
Where DIY goes wrong on Toto specifically: replacing a fill valve on a 1.28-gallon Eco model without matching the flow rate leaves you with a toilet that flushes but doesn’t refill the bowl, and you’ll be back in the same spot in a week. Replacing electronics on a Washlet or Neorest involves a control panel and water supply – a wrong connection can leak behind the wall. And anything involving the wax ring, flange, or shower membrane is a water-damage problem waiting to happen: once water gets under the tile, you’re not replacing a $12 part, you’re replacing the substrate.
Call (833) 842-1866 for a free estimate. We’ll tell you what we found, show you the photo record, and write the price before we start.
FAQs

A Toto fill valve typically lasts 6 to 10 years; a flapper, 3 to 5. Santa Rosa’s water is on the harder side, and homes on older service lines wear rubber and seals faster. If your toilet is over 8 years old and starting to run, the parts are near end of life together – replace the fill valve and flapper as a set. Call (833) 842-1866 for a written quote.
Yes, most toilet and fixture failures are repairs, not replacements. A flapper, fill valve, wax ring, or supply line swap is a small job compared to a full remodel. The exception is a cracked porcelain bowl, a failed Neorest control panel, or a shower whose membrane has already leaked – those are replace, not repair. Call (833) 842-1866 and we’ll tell you which side you’re on.
A toilet or fill valve replacement is a same-day job, typically under two hours. A vanity install is a half-day. A full Toto bathroom remodel in Santa Rosa runs 2 to 4 weeks depending on tile and whether the subfloor needs work – the schedule is written on your quote before we start, not promised on the phone.
By model number, from Toto’s OEM line or a quality aftermarket equivalent where we can verify the spec. We don’t claim to stock parts or carry them on a truck – we order against your model and bring the right one. We also service KraftMaid, Cambria, and Silestone bath products – cabinets and counters – on the same remodels. Call (833) 842-1866 to schedule your free estimate.
Call (833) 842-1866 to schedule your free estimate for Toto bathroom remodeling in Santa Rosa. Every quote is a written flat price with a written scope before work starts, every visit includes a documented photo record, and every job is backed by the 365-Day Done Right Promise. You’ll get a second opinion on any written estimate at no charge.
Written by the team at Rowan Construction Group Santa Rosa, serving Santa Rosa and nearby areas.












