







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CGI Driveway & Pavers: The Santa Rosa Owner’s Guide
We install, replace and repair CGI driveway and paver systems for Santa Rosa homeowners, and most full paver driveway projects here land between $7,000 and $18,000 installed. Concrete driveway installation runs $4,500 to $12,000, and driveway sealing is $250 to $700. Rowan Construction Group Santa Rosa is an independent service provider and is not affiliated with CGI. You’ll usually know something’s wrong before you see a hole: a low corner where water pools after rain, pavers that rock when you step on them, sand washing out of the joints, or a hairline crack that widens through a wet winter.
Which CGI Models This Applies To

CGI covers a wide spread of paver and driveway products, and the part number on your original paperwork is what settles compatibility. Look for the stamped mark on the paver edge or the spec sheet in your closeout folder; field measurements alone will get you close on size but can miss thickness, which is where CGI pavers vary most.
Standard CGI pavers come in nominal thicknesses around 2 3/8 inches for pedestrian and light driveway use, with heavier units closer to 2 3/4 or 3 inches for full vehicle loads. Mixing a thin paver into a driveway field set for a heavier unit is the compatibility mistake we correct most often in Santa Rosa. On fasteners, edging and base components, the OEM route keeps things simple; a quality aftermarket equivalent works fine when the spec matches, and we’ll tell you which one the written quote is based on.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CGI Driveway & Pavers Is Failing
- Pavers rocking underfoot. Usually a base that wasn’t compacted or bedding sand that has migrated out. The paver itself is often fine; the layer under it isn’t.
- Sand washing out of the joints. In Santa Rosa’s winter rain, unsealed joints lose sand fast. Wide, empty joints let water into the base and speed up settling.
- Ponding in one corner. Water sitting more than a day after rain points to a low spot or a slope that drains toward the house instead of the street.
- Cracks along the edge or through a unit. Edge restraint that’s come loose lets the field spread. A cracked paver in a driveway is usually carrying load it shouldn’t.
- Weeds pushing up between units. Organic growth in the joints is normal over time; weeds rising from below mean the joint sand and base have opened up.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

What drives the range is linear feet, paver thickness and base depth required for your soil, whether the existing base can be reused, and access. Tight Santa Rosa driveways off narrow streets add handling time and change the number.
Every quote is a flat written price with a written scope, and no change proceeds until the change order is signed. Work is backed by the 365-Day Done Right Promise.
| Project | Installed range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
Parts and labor are shown as separate lines so you can see what the material costs and what the crew costs. Bring a competitor’s quote and we’ll review it line by line at no charge as a free second opinion.
DIY or Call Us?
You can safely handle the inspection side: walk the driveway after rain and note where water pools, press down on suspicious pavers to check for rock, and photograph the joints before and after a storm. That record is useful.
Where it goes wrong is in base work. Replacing a paver on a failed base just resets the clock on the same problem; proper compaction and edge restraint take equipment most homeowners don’t have. And lifting a driveway field over a utility line or near a garage slab is a job for someone who knows what’s buried there. Call (833) 842-1866 and we’ll give you a written price before anything is touched, with a documented photo record of what we find.
FAQs

Properly installed CGI pavers can last 25 to 30 years or more. The base and edge restraint fail before the paver does, and Santa Rosa’s wet winters are the real test.
Yes, in many cases. If the base is sound, lifting and resetting a few pavers plus re-sanding and sealing costs far less than a full install. We’ll tell you which one your driveway needs.
A typical single-car driveway replacement in Santa Rosa runs 3 to 5 working days, weather depending. Larger or complex jobs take longer, and the schedule is written into the quote.
We match by the stamped mark or spec sheet from your original install, and confirm thickness before ordering. Call (833) 842-1866 for a free estimate and we’ll verify the part against your driveway, not a catalog photo.
We also work with KraftMaid, Cambria and Silestone on the interior side of the house, in case your project grows.
Call (833) 842-1866 for a free estimate with a written price before any work starts.
Written by the team at Rowan Construction Group Santa Rosa, serving Santa Rosa and nearby areas.












