







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Barrette Driveway & Pavers: The Santa Rosa Owner’s Guide
We install and repair Barrette outdoor hardscape systems across Santa Rosa, and a paver driveway typically runs $7,000 – $18,000 installed, with a paver patio at $3,500 – $11,000. Barrette does not make a single “driveway part” you swap in an afternoon. What fails on a Barrette driveway or paver patio is one of four components: the paver units themselves, the polymeric joint sand, the edge restraint, or the compacted base underneath. Owners usually find out the same way. A paver rocks underfoot after a wet winter, sand washes out of the joints and weeds appear along the driveway apron, or an edge course starts walking outward toward the street. Once one course shifts, the failure spreads, and the fix is rarely one stone.
Which Barrette Models This Applies To
Barrette Outdoor Living sells interlocking pavers and patio slabs through several lines, and the profiles differ enough that a paver from one series will not match the thickness or the interlock of another. The practical way to identify what you have is to lift a loose unit and measure it: length, width, and thickness in millimeters. Most Barrette driveway pavers sit in a 60mm to 80mm thickness band, and a driveway needs the heavier end of that range because it takes vehicle loads. Patio and walkway units are thinner. Check the underside of the paver for a stamp, then match that number to the current Barrette spec sheet rather than to a photo on a retailer’s page. On replacements, the honest call is between pulling from existing inventory in the same series or re-cutting an edge course to hide a mismatch. We quote both. Where the exact Barrette series is discontinued, we’ll tell you before you commit rather than after.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Barrette Driveway & Pavers Is Failing
- Pavers rocking or dipping underfoot. The base beneath has settled or lost compaction, usually after a Santa Rosa rainy season pushes water into a low spot. The paver is fine; the support under it is not.
- Joint sand washing out. Polymeric sand breaks down when water pools instead of draining, and once the joints open, weeds seed in and the interlock loosens. Re-sanding is a real fix only if the drainage is corrected first.
- Edge course spreading outward. The edge restraint has pulled loose from the base, or was never pinned properly. Left alone, the whole field of pavers creeps and gaps widen.
- Efflorescence and white haze that won’t scrub off. Mineral salts wicking up through the paver from a wet base. A surface wash won’t cure it; the moisture source has to be addressed.
- Cracked or chipped units along the driveway apron. Point loads from turning tires or a base that flexes. Matching a single cracked paver is easy; the crack returning is the tell that the base is the problem.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Pricing in Santa Rosa depends on square footage, whether the base is sound, and how much of the system gets replaced.
| Work | Installed range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
A targeted repair of a failed edge course or a re-sand sits well under those figures; a full tear-out and rebuild sits at the top. The quote is a flat price with a written scope before work starts, and the work carries our 365-Day Done Right Promise. We also pull the photo record on every visit, so you see the base condition, not just the finished surface.
DIY or Call Us?
You can safely check a few things yourself: measure a loose paver, look for a stamp on the underside, and note where water pools after rain. What goes wrong with DIY is the base. Most homeowner paver repairs fail because the unit goes back on uncompacted soil, the edge restraint isn’t pinned, or the polymeric sand is installed wet and never sets. That’s a re-do, not a fix. A paver driveway is heavy work with no high-tension danger, but the compaction step is what separates a repair that lasts from one that fails by the next rainy season. Call (833) 842-1866 and we’ll give you a written price and an honest read on whether you need a repair or a rebuild.
FAQs

The pavers themselves hold up 25 to 30 years or more; the joint sand and edge restraint are what need attention sooner, often every few years in our wet winters. The base is the real lifespan limit. Call (833) 842-1866 for an on-site look.
Usually yes, if the failure is one edge course, washed-out joints, or a handful of cracked units. If the base has settled across the driveway, a repair will keep returning. We tell you which one it is before quoting.
A targeted repair or re-sand is typically one to two days. A driveway rebuild takes longer because the base has to be excavated, recompacted, and set before any pavers go down. We’ll give you the timeline in the written scope.
We match on the measured dimensions and the stamp on the paver underside, then confirm against the current Barrette spec sheet. If the series is discontinued, we say so up front and quote a compatible match rather than guessing. We also work with KraftMaid, Cambria, and Silestone on other trades. Call (833) 842-1866 to schedule a free estimate.
Written by the team at Rowan Construction Group Santa Rosa, serving Santa Rosa and nearby areas.












