







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Kitchen Remodeling: The Santa Rosa Owner’s Guide
Kitchen remodeling work matched to ActiveYards products in Santa Rosa typically runs $14,000 – $45,000 installed, with the wide spread driven by cabinet line, countertop material, and how much of the room’s layout changes. That figure covers the cabinets, counters, and finishes that carry an ActiveYards label in a kitchen or that collide with ActiveYards exterior components when a remodel opens the wall line. It is a written number before anyone picks up a tool, not a phone estimate.
Owners usually discover a failure in pieces. A drawer face in an ActiveYards cabinet line stops closing flush, the soft-close damper gives up, or a counter seam over an ActiveYards base unit lifts after two wet winters. Sometimes the trigger is outside: an ActiveYards fence or railing assembly that a kitchen project abuts gets disturbed, and the parts that connect the two no longer line up. We’re an independent service provider, not affiliated with ActiveYards. When a part has genuinely failed, the honest answer is usually a matched replacement, not a rescue.
Key Takeaways
- Installed kitchen remodeling in Santa Rosa: $14,000 – $45,000; small kitchen remodel: $9,000 – $20,000.
- Cabinet installation alone: $4,000 – $13,000; countertops: $2,000 – $6,500.
- We don’t stock ActiveYards parts or carry them on a truck. We source the correct part to your model, then install.
- Every job starts with a flat written price, written scope, and written warranty. No change proceeds until a change order is signed.
- Free second opinion on any written estimate you bring us.
Which ActiveYards Models This Applies To

ActiveYards builds across several product families, and the part that fits one line won’t fit another. Cabinet and millwork components key to the series and the run length; a face frame or drawer box from a 30-inch run won’t slot into a 36-inch unit without modification. Railing, gate, and post-cap components from activeYards’ vinyl lines follow their own sizing, and a post cap spec’d for a 4-inch post won’t seat on a 5-inch post without a reducer. The first step is finding the model sticker, which lives on the inside of a cabinet door or on the back panel of a drawer carcass, or on the fence post collar. If the sticker is gone, measure the opening, the run, the door thickness (typically 3/4-inch on ActiveYards millwork) and the hardware bore spacing.
Then comes the OEM-versus-aftermarket decision. For structural parts – a hinge, a drawer slide, a cabinet leg – we use OEM-equivalent parts that match the bore pattern and load rating, because a mismatched slide will pull out of the pilot hole within a few months. For cosmetic parts like door faces, an aftermarket equivalent dyed to match the finish is often the honest choice when OEM stock has dried up. We tell you which path we’re taking and why, with the spec in writing. We source KraftMaid and Wellborn cabinetry, Cambria and Caesarstone counters, and Silestone surfaces, so matching a finish against ActiveYards millwork is a known problem, not a guess.
Santa Rosa’s own label habit matters too. Homes built between 1950 and 1985 in neighborhoods like Junior College and Bennett Valley often have ActiveYards product installed as a later upgrade, so the model line rarely matches the home’s build era. We check the actual part, not the year on the deed.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ActiveYards Kitchen Remodeling Is Failing
- Drawer faces that stop closing flush. Usually a failed soft-close damper or a slide that’s lost its detent. Once the damper fails, the drawer slams and the repeated impact loosens the slide mounting screws.
- Cabinet door that sits proud at the bottom. A sagging hinge plate. ActiveYards millwork uses a euro-style hinge that can be adjusted, but the screw holes in the frame enlarge over time, so adjusting gets harder each season.
- Counter seam over an ActiveYards base unit lifts. Moisture from a leaking dishwasher or a sink caulk failure swells the substrate under the seam. Left alone, the swollen particleboard will push the seam line out of flat every spring.
- Cabinet boxes racking on uneven floors. Santa Rosa’s older homes and slab edges settle, and a base unit that was perfectly square at install goes out of square. Doors then won’t sit flush and the drawer fronts go crooked.
- Fence or railing post knocked out of line. When an ActiveYards fence runs along a wall a kitchen project touches, a disturped post collar or a cracked cap lets rain into the post top. That does not cause a kitchen failure, but it means the adjacent component has to be re-set as part of the job.
We’ve seen the pattern in Natomas-style climate too, and it plays out the same in Santa Rosa: a wet winter followed by a dry summer pries seams open faster than owners expect. If you see more than two of the symptoms above at once, the honest next step is a written estimate, not a touch-up.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed price ranges for this work in Santa Rosa, kept honest and itemized:
| Scope | Price Range (Santa Rosa) |
|---|---|
| Kitchen remodel (full, with ActiveYards-matched millwork) | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What drives the number: the cabinet line and whether it must be matched to an existing ActiveYards finish, the counter material (Cambria and Caesarstone sit higher than Silestone), and how much layout moves. Each quote is a flat written price with a written scope and written warranty. If the work reveals a swollen substrate or a racked wall that wasn’t visible, that’s a change, and a change order comes to you signed before any tool moves. Labor and parts are on the same line, itemized. The 365-Day Done Right Promise backs the work: if it isn’t right, we make it right.
DIY or Call Us?
What an owner can safely check: the model sticker, the door thickness, the hinge bore pattern, and whether a cabinet is level (a 4-foot level on the face frame tells you). You can also confirm a drawer slide’s detent by listening for the click. What goes wrong when an owner takes it further: adjusting a euro hinge more than once can strip the mounting screws in the frame, and re-caulking a lifting counter seam over a swollen substrate seals moisture in rather than out. Cabinet and countertop work involves lifting 60-pound base units and cutting a seam that will show for years if it’s off. Reach for the phone at (833) 842-1866 for a free estimate. Bring a photo of the sticker and we’ll tell you exactly what we’ll match.
FAQs

Expect 10 to 15 years from cabinet hinges, drawer slides, and soft-close dampers under normal use, and 20-plus years from the carcass itself if the room stays dry. Santa Rosa’s wet winters and dry summers are hard on wood composite, and a leaking sink or dishwasher halves that cabinet lifespan – so the hinge on a cabinet under a sink usually goes first. If you’re seeing multiple failures at once, call (833) 842-1866 for a free estimate.
Sometimes, yes. A soft-close damper and a euro-hinge plate are replaceable on their own, and we’ll tell you when a repair is the honest answer and when the frame screw holes are too wallowed out to hold a new hinge. A swollen substrate under a counter seam and a racked cabinet box are not repairable in place; those get replaced. We price both paths in writing so you can see the difference. Call (833) 842-1866 to get the number.
A single hinge or slide swap is a same-visit job. A door-face replacement runs to the finish-match lead time, generally one to three weeks. A full cabinet run or a counter with a seam repair is scheduled as a project, and the written scope tells you which. The photo record from every visit means you see what we found and what we did. Call (833) 842-1866 for a free estimate.
We match the part to your model using the sticker and the measurements, then order the OEM or OEM-equivalent component and confirm the spec in writing before install. We don’t claim to carry ActiveYards parts on a truck or to stock them locally. If the correct part is discontinued, we say so and quote the closest aftermarket equivalent with the spec shown. Call (833) 842-1866 for a free estimate and a free second opinion on any written quote you already have.
Santa Rosa kitchens are a mix of 1950s ranches and newer infill, and we’ve seen both, across ActiveYards cabinetry, KraftMaid and Wellborn lines, Cambria, Caesarstone, and Silestone counters. We’re a construction contractor, not a parts counter. What we show you is a flat written price, a written scope, a written warranty, background-checked and uniformed technicians, calls answered by a live person 24/7, and a documented photo record on every visit. Call (833) 842-1866 to schedule your free estimate. Estimates are free, the second opinion is free, and the price doesn’t change without your signature.
Written by the team at Rowan Construction Group Santa Rosa, serving Santa Rosa and nearby areas.












