







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Fence Installation: The Santa Rosa Owner’s Guide
We install ActiveYards fence systems across Santa Rosa, and a full vinyl or aluminum run typically lands between $3,500 and $9,000 installed. Most owners don’t call us about the fence itself. They call about a section that has started to lean, a post that rocks in its footing, a gate that drags the ground, or a rail that has pulled loose from its post cap after a wet winter. That cluster of symptoms is the fence telling you the hardware, the footing, or a single component has reached the end of its service life, and the fix is narrower than a whole new run.
Rowan Construction Group Santa Rosa is an independent contractor, not affiliated with ActiveYards. We source the matching profiles and brackets and set the posts correctly the first time, which is where the majority of ActiveYards failures in Sonoma County begin.
Key Takeaways
- ActiveYards vinyl and aluminum runs in Santa Rosa run $3,500 to $9,000 installed.
- Most failures trace to the footing, not the panel: our clay-heavy soils and winter water table heave posts that weren’t set deep enough.
- Every quote is a flat written price with a written scope before work starts.
- Post-and-rail swaps are usually a day or less; a full run replacement is a scheduled project, not an emergency call.
Which ActiveYards Models This Applies To

ActiveYards makes more than one fence line, and the profile matters because the rails, caps and pickets are not interchangeable across them. The main families you’ll see on a Santa Rosa residential lot are Grand Illusion, which mimics the look of real wood planks; Wakefield, a classic picket profile; and the aluminum Tuscany and Grandview lines, which sit in the $4,000 to $10,000 installed band and are often used for view fences and pool surrounds. Each line has its own post cap, rail bracket and picket spacing, so a part pulled from a Wakefield run won’t seat in a Grand Illusion channel.
To identify what you have, look for the manufacturer stamp or foil label on the inside face of a rail, usually within a foot of a post. Measure picket width and spacing in inches and write it down; ActiveYards has changed rail dimensions across production years, so the measurement matters more than the model name. On the OEM-versus-aftermarket question, ActiveYards-branded caps and brackets are the safe match. A quality aftermarket rail bracket from a fencing supply house works fine when the dimension is right, and costs less. What we won’t do is force a part that’s close. Under Clause 1 of the Haven Standard, we write the exact profile and dimension into the quote before anyone touches the fence, so there are no surprises at the truck.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ActiveYards Fence Installation Is Failing
- Posts that rock or lean after rain. This is a footing problem, not a panel problem. In Santa Rosa’s clay soils, water collects around a post that was set too shallow or without proper drainage, and the ground swells and shrinks until the post works loose.
- Rails that have pulled out of the post channel. The bracket or channel insert has failed, often from UV brittleness on a sunny south-facing run. The rail is usually fine and the connection is what needs replacing.
- Sagging gates that drag on the ground. The hinge has loosened or the gate post has shifted. A gate that needs lifting to close is a hinge and post issue, not a whole-gate replacement.
- Cracked pickets or caps, especially at ground level. Vinyl gets brittle with sun exposure and temperature swings. A hairline crack at the bottom of a picket lets water in, and one hard freeze finishes the job.
- Rust weeping at aluminum joints. On Tuscany or Grandview aluminum runs, surface staining at a bracket means the finish has been breached and moisture is getting to the base metal. Catch it early and it’s a fitting swap; wait and it’s a section.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a Santa Rosa ActiveYards fence installation, plan on $3,500 to $9,000 for a typical residential run, with aluminum lines from $4,000 to $10,000 depending on height and length. The number moves with linear footage, gate count, post depth and whether we’re matching an existing profile or replacing a full run. A small repair, such as re-setting one post or swapping gate hardware, comes in well below the full-run range and we’ll tell you plainly when that’s all you need.
Our quotes are parts-plus-labor, itemized, so you can see the hardware cost separate from the digging and setting. The written price is fixed before any work starts, and no change proceeds without a signed change order. Every job is backed by the 365-Day Done Right Promise: if it isn’t done right, we make it right. Call (833) 842-1866 for a free estimate, and bring any written quote you already have for a free second opinion, reviewed line by line at no charge.
DIY or Call Us?
An owner can safely do the diagnosis: walk the run, push on each post to find the loose ones, check the gate swing, and photograph every cracked cap. That information makes the estimate sharper.
Where DIY goes wrong with fence installation is the footing. Digging out a post in Santa Rosa’s clay, getting the depth and drainage right, and setting a new post so it doesn’t heave next winter is heavier work than it looks, and a badly set post fails again within a season. Vinyl and aluminum panels are also awkward and light enough to bend or crack when handled alone. We’d rather you check what you can and hand off the setting. Call (833) 842-1866 to schedule your free estimate; a live person answers around the clock.
FAQs

How long does an ActiveYards fence last in Santa Rosa? A properly set ActiveYards vinyl or aluminum run typically lasts 15 to 20 years or more in Sonoma County’s climate, but the panels often outlast the footings. The posts are what we see fail first, usually because they were set too shallow for our clay soil. Call (833) 842-1866 if a post is rocking; estimates are free.
Can the fence be repaired instead of replaced? Usually, yes. A single loose post, a failed bracket, or a dragging gate is a targeted repair, and we’ll tell you when a repair is the honest answer rather than quoting a full run. Call (833) 842-1866 and we’ll put the range in writing before any work starts.
How long does a post or section swap take? A single post re-set or a gate hardware swap is often a day or less. A full run replacement is a scheduled project, typically a few days depending on length and gate count. We confirm the timeline in the written quote.
How do you source the matching ActiveYards part? We match the profile and dimension from your existing run, verify it against the manufacturer spec, and name the exact part in the written scope. If the correct OEM piece isn’t available, we specify a compatible aftermarket equivalent and note it. Call (833) 842-1866 for a free estimate. We also work with KraftMaid, Cambria, and Silestone on other trade projects.
Written by the team at Rowan Construction Group Santa Rosa, serving Santa Rosa and nearby areas.












