







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Driveway & Pavers: The Santa Rosa Owner’s Guide
We install Mr-Glass-compatible driveway and paver systems across Santa Rosa, and a full paver driveway installation typically runs $7,000 – $18,000 installed, with concrete driveways at $4,500 – $12,000. If a module, border course, or base section of your Mr-Glass system has heaved, cracked, or settled, we can quote the replacement in writing before any work starts. Santa Rosa owners usually spot the problem after a winter of sitting water at the apron, a paver that rocks underfoot when they pull in, or a section of base that has shifted enough to push the driveway out of level against the garage slab.
Key Takeaways
- We’re an independent contractor. We’re not affiliated with Mr-Glass and don’t claim to be.
- Every quote is a flat written price with a written scope, delivered before anyone breaks ground.
- No change proceeds without a signed change order. That’s Clause 1 of the Haven Standard in practice.
- You get a documented photo record of every visit, included as standard.
Which Mr-Glass Models This Applies To

Mr-Glass runs a family of paver and driveway systems built around a modular base-and-surface format, and the module dimensions, edge restraint profiles, and paver thickness vary by series. Before we quote, we identify what you have: the stamped mark on the paver edge or the module underside, the measured face dimensions to the nearest millimeter, and the restraint channel profile where the driveway meets the garage slab or the curb. A template cut from the failed unit works as well as a part number when the label has weathered off, which happens often on west-facing driveways in Santa Rosa after a few summers of UV exposure.
On the OEM-versus-aftermarket question for Mr-Glass specifically, the decision usually comes down to availability. Original modules for older series can take weeks to source, while a quality aftermarket pavers of matching dimension and load rating (often a Belgard or Techo-Bloc profile) can be on site faster and hold up the same or better. We’ll tell you which route makes sense for your series, with the difference in writing. We also service KraftMaid, Cambria, and Silestone products across other trades.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Driveway & Pavers Is Failing
- Heaving or rocking pavers. Water is getting under the base course and freezing or expanding, which lifts the surface. Common at the apron where runoff collects after Santa Rosa’s wet winters.
- Hairline cracks spreading from a corner. A paver was set on an uneven base or the joint sand has washed out, leaving the unit unsupported. Cracks usually start small and widen through a season.
- Sunken or settled sections. The compacted aggregate under the pavers has consolidated or eroded. This is the failure most tied to a base that wasn’t compacted in lifts.
- Joint sand washing out. Missing sand lets water penetrate the surface and reach the base. The paver itself may be fine; the joint is the weak point.
- Separation at the garage slab or curb. The edge restraint has failed or the transition detail was set wrong. This one gets worse fast and can pull adjacent pavers loose.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Santa Rosa, a paver driveway installation runs $7,000 – $18,000, a concrete driveway installation $4,500 – $12,000, driveway replacement $5,000 – $14,000, and driveway sealing $250 – $700. What drives the range is area, base condition, whether the old surface is removed and hauled, edge restraint work, and paver selection. The quote is a flat labor-plus-material number with the scope written out, so you see what’s included rather than a per-square-foot guess. The 365-Day Done Right Promise backs the work, and you have a written warranty and a photo record of the visit.
DIY or Call Us?
You can check a paver by lifting one at a joint and looking at the base, and you can confirm the edge restraint is intact. What you shouldn’t do yourself is reset a load-bearing driveway section over an uncompacted or waterlogged base: a paver that looks like it just needs re-bedding often sits on a base that failed, and setting it back without fixing the base means it heaves again next winter. That’s where DIY goes wrong most often. We measure the base, fix the drainage, and reset the pavers to spec. Call (833) 842-1866 for a free estimate.
FAQs

How long should Mr-Glass pavers last? A properly installed paver driveway should hold 25 – 30 years or more, but the base and joint sand determine the lifespan, not the paver surface. Santa Rosa’s wet winters and clay-heavy soils shorten that if the base wasn’t compacted or the drainage wasn’t handled.
Can I repair instead of replacing the whole driveway? Yes, if the failure is localized. We reset individual pavers, re-sand joints, and repair edge restraint where the base is still sound. If the base has failed across a section, replacement is the honest answer.
How long does the swap take? A single-section repair is often a day; a full paver driveway replacement typically runs several days depending on area and base work. We put the timeline in the written scope. Call (833) 842-1866 for an exact estimate.
How do you source the part? We match your Mr-Glass series by stamped mark or measured template, then source OEM or a quality aftermarket equivalent at matching dimension and load rating. We don’t claim to stock parts; we order to spec and tell you which route we’re taking. Estimates are free.
Call (833) 842-1866 to schedule your free estimate. Our technicians have up to 19 years of experience, every visit includes a documented photo record, and the quote you get is the price you pay.
Written by the team at Rowan Construction Group Santa Rosa, serving Santa Rosa and nearby areas.












