







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Fence Installation: The Santa Rosa Owner’s Guide
Wellborn fence installation in Santa Rosa typically runs $3,500 to $9,000 fully installed, and most projects are scheduled within one to three weeks of a signed, written price. That range covers removal of the old fence, posts set in concrete, and a written workmanship warranty. Owners usually discover the need for replacement the same way: a section leans after a wet winter, gate hardware no longer lines up, or the post base has gone soft where it meets the soil. On a Wellborn-branded fence, that hardware matters. The gate hinges, latch plates, and post brackets are proprietary, and a generic replacement from a big-box aisle won’t seat correctly. We source the correct Wellborn-compatible hardware through our vetted supplier network before the crew arrives.
Key Takeaways
- Installed Wellborn fence replacement in Santa Rosa: $3,500 to $9,000.
- Wellborn gate hardware is proprietary, so aftermarket hardware often won’t seat without modification.
- Redwood posts in Santa Rosa soil commonly show softness at grade within 8 to 12 years.
- A written, flat price comes before the work starts, under Clause 1 of the Haven Standard.
- We’re an independent contractor, not affiliated with Wellborn.
Which Wellborn Models This Applies To

We work with Wellborn’s residential fence lines: their redwood and cedar privacy panel systems, the composite series, and the aluminum ornamental gate packages that ship with matching post caps and hinges. Wellborn doesn’t stamp a model number on the rails, so identification requires a measurement, not a label. Measure the panel height, the rail thickness, and the post cross-section. Wellborn’s common privacy panel runs a 4-by-4 post with a 2-by-3 rail; their ornamental aluminum uses a 2-inch square post with a scalloped hinge bracket that won’t match a standard strap hinge. Bring those three measurements when you call, and we can identify the correct replacement hardware and panel spec before anyone orders.
When it comes to the OEM-versus-aftermarket call: for the panel boards, a quality aftermarket redwood or composite equivalent is a fine match, often at a lower price, and we’ll tell you where the savings are honest. For the gate hardware and post brackets, go OEM. The aftermarket hinge that almost fits is the one that fails first. KraftMaid, Cambria, and Silestone are also in our vetted brand network, and our sourcing depth across fifty-plus brands is what lets us quote accurate numbers on the Wellborn-compatible parts rather than padding the estimate.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Fence Installation Is Failing
Fence failure is rarely sudden. It’s a slow sequence of conditions, and here’s what each symptom usually means:
- Post leaning after a wet season: Santa Rosa’s clay-heavy soil holds moisture and swells, then shrinks in summer. That cycling loosens the concrete collar around the post, and the post rotates. A lean of more than a few degrees usually means the base has to be reset.
- Soft wood at soil line: Ground contact is where rot starts, because the post wicks moisture at grade. Probe the post base with a screwdriver; if it sinks easily, the post is compromised even if the top looks fine.
- Gate sag and hardware misalignment: A gate that drags or won’t latch usually has a failed hinge or a post that’s shifted. Wellborn’s proprietary hinge bracket won’t accept a generic swap, which is why the correct part matters.
- Loose or popped rails: Fasteners back out when the wood expands and contracts through the seasons. Repeated tightening won’t fix a rail that’s too thin for the post pocket.
- Fading or chalking on composite panels: Wellborn’s composite series holds color well, but sun-facing panels in Santa Rosa’s heat can chalk on the south face after years. Chalking is cosmetic; chalk alone isn’t a reason to replace.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a Wellborn fence replacement in Santa Rosa, the installed price is $3,500 to $9,000. What moves the number:
- Linear footage and height: A short privacy run at 6 feet sits near the bottom; a long run or a taller panel climbs toward the top.
- Material: Redwood and composite premiums run higher than pressure-treated; aluminum ornamental sits in the middle.
- Removal and disposal: Hauling off the old fence, concrete and all, adds cost.
- Gate hardware: Wellborn-compatible hinges, latches, and brackets are a line item, priced separately and quoted honestly.
- Site conditions: Rocky or sloped ground, or a shared-property line, can add labor.
Every quote is a flat written price with a written scope, and the warranty on the workmanship is in writing before the crew shows up. No work proceeds on any change until the change order is signed. The 365-Day Done Right Promise means if it isn’t done right, we make it right.
DIY or Call Us?
You can safely measure the panel height, rail thickness, and post cross-section, probe the post base for softness, and photograph the gate hardware to identify the part. That’s information gathering, and it’s useful.
Where DIY goes wrong: setting a post in Santa Rosa’s clay at the right depth with the right concrete and drainage is a job, not a weekend. A post set too shallow leans within a season. And a gate hung on aftermarket hardware that almost fits tends to fail at the hinge, which can mean a swinging gate and a real injury risk if it lets go. We recommend a trained crew for post setting and gate hanging. Our technicians have up to 19 years of experience, they’re background-checked and uniformed, and every visit includes a documented photo record of what we found and what we did. Call (833) 842-1866 to schedule a free estimate, or bring a competitor’s quote for our free second opinion.
FAQs

A well-installed Wellborn redwood or cedar fence typically lasts 12 to 18 years in Santa Rosa’s climate, given ground-contact posts and drainage; composite panels often last longer, and aluminum can outlast both. The weak point is the post base at grade, which is why we set posts deep and pour a proper concrete collar. Call (833) 842-1866 for an exact quote on your run; estimates are free.
Often yes, and we’ll tell you when repair is the honest call: a single leaning post, a failed hinge, or a few loose rails can be fixed without replacing the whole fence. A fence with several soft posts, or widespread rot along the rails, is usually past repair. Call (833) 842-1866 and we’ll assess it in person at no charge.
A typical residential Wellborn fence replacement in Santa Rosa takes two to four days, depending on linear footage, ground conditions, and gate count. Removal and post setting come first; the panels and gates follow. Your written scope will state the schedule before work starts. Call (833) 842-1866 to schedule your free estimate.
We identify your system by measurement (panel height, rail thickness, post cross-section) and order the matching Wellborn-compatible hardware and panels through our vetted supplier network, so the gate hardware seats correctly. We don’t carry parts on a truck; we source to your spec and quote the part as a written line item. Call (833) 842-1866 to start.
If your Wellborn fence is leaning, soft at the base, or fighting its gate, the fix starts with a number on paper. Call Rowan Construction Group Santa Rosa at (833) 842-1866 for a free estimate: a flat written price, a written scope, and a documented record when the crew leaves. The process starts with the written price, and nothing gets picked up until you’ve signed it.
Written by the team at Rowan Construction Group Santa Rosa, serving Santa Rosa and nearby areas.












